Or simply go through the following pages with links to the relevant articles
Page 13 of 14
- page 1
- page 2
- page 3
- page 4
- page 5
- page 6
- page 7
- page 8
- page 9
- page 10
- page 11
- page 12
- 13
- page 14
-
Size, corner radius, straightness, twist and ‘out-of-squareness’ tolerances for square bars are tabulated along with notes on measurement methods.
-
Diameter, ovality and straightness tolerances for round bars are tabulated along with notes on measurement methods.
-
Size, (width across flats), corner radius, straightness, twist and ‘out-of-section’ tolerances for hexagon bars are tabulated along with notes on measurement methods.
-
Specific features of the European dimensional tolerance for cold rolled narrow stainless steel strip are described. The tolerances covered are thickness, width, length, flatness and edge waviness, out-of-squareness and edge camber.
-
Specific features of the European dimensional tolerance for cold rolled wide stainless steel strip are described. The tolerances covered are thickness, width, length, flatness and edge waviness, out-of-squareness and edge camber.
-
Tolerances for bright drawn, ground, turned and polished stainless steel bars are shown to BS EN 10278, derived from tolerance classes to ISO 286-2. The shapes covered include round, hexagon, square and flat bar sections and include. Cross section, (diameter, width, thickness, across flats), ovality, length and straightness tolerances are tabulated.
-
In addition to chemical composition and mechanical properties, BS EN 10296-2 also gives tolerances for straightness, outside diameter, wall thickness, length, height of weld seam,
-
In addition to chemical composition and mechanical properties, BS EN 10297-2 also gives tolerances for straightness, outside diameter, wall thickness and length
-
A summary of tolerances for hot rolled plate, also known as quarto plate, i.e. rolled as flat plate on a reversing mill. Not applicable to plate cut from coil also known as CPP, continuously produced plate. Covers thickness, width, length, flatness, out-of-squareness and edge camber.
-
The EN standard applicable to continuously hot rolled plate sheet and strip, also known as CPP. Covers tolerances on thickness, width, length, flatness, out of squareness, edge camber and crown. It has been superseded by ISO 9444
